Subject	Dual Maf - Add vs Average setup
Posted by	kurt81 on February 02, 2010 at 12:24 PM
	This message has been viewed 143 times.
Message	Hi guys, i have a question: i have installed a dual maf setup with an ApexiNeo Safc. I have read that the "add" setup is good for 800CFM: it uses the single pop program and it add the two voltages. But our maf can read from 0 to 5 volts. Im running an IPP stage5 engine with jwt700turbos at 20psi (around 600rwhp). I think that for this setup could be better to use a dual pop ecu with the average function on the safc, right? With the add function im afraid to go over 5volts... Thanks ^_^''
Follow Ups	Dual Maf - Add vs Average setup - kurt81 12:24:28 02/02/10 From what I've read - Broke_as_**** 17:03:20 02/02/10 use average if you plan to make more than 600whp (n/m) - ztunerz 00:20:41 02/03/10 With those turbos I'd go with the dual pop ecu - CaliguyPurdue (Selin Design) 11:58:46 02/03/10 Re: Dual Maf - Add vs Average setup - kurt81 01:36:54 02/06/10
Post a Followup	You cannot reply to this message because you are not logged in.