Subject	Inspect the connectors for green corrosion and clean>>
Posted by	ZUL8TR on January 31, 2010 at 4:07 PM
	This message has been viewed 76 times.
In Reply To	Re: Use a digital voltmeter - on resistance setting and verify posted by ZaddicteD on January 30, 2010 at 03:03 PM
Message	also look at the connector prongs in the injector and clean them as well. Use chemical clean. Fill connector with dielectric grease and replug. If connectors cannot be cleaned you probably need to replace them. Sometimes the full corrosion is not known until the wires leading into the connectors are inspected because the corrosion will travel up the wire - it happened to me. ZUL8TR in Orlando,FL
Follow Ups	How to check if injectors are good.. - ZaddicteD 13:59:32 01/30/10 Use a digital voltmeter - on resistance setting and verify - jzack 14:41:25 01/30/10 Re: Use a digital voltmeter - on resistance setting and verify - ZaddicteD 15:03:00 01/30/10 If I remember correctly -- they seem to be OK but not - jzack 09:07:03 01/31/10 Inspect the connectors for green corrosion and clean>> - ZUL8TR 16:07:37 01/31/10
Post a Followup	You cannot reply to this message because you are not logged in.