Subject	Re: "it really isn't that hard." Thats music to my ears...
Posted by	BeaZty on January 30, 2010 at 11:03 AM
	This message has been viewed 193 times.
In Reply To	Re: Thanks Marty, your tips are greatly appreciated. posted by Marty1Mc on January 30, 2010 at 08:21 AM
Message	especially after some of the recent bushing upgrade work I have done on the car. Ya, I would never take the car to the Nissan dealer to get work done. They tried to rip me off and tell me I needed an engine pull and turbo replacement because my car wouldn't rev past 3500rpms. I checked the ecu myself for codes and I just needed a new mass air flow sensor. After that no one touches the car now but me.
Follow Ups	stripped threads inside bolt hole of plenum to balance tube. - BeaZty 15:55:57 01/27/10 Passenger side should be using a nut, not a bolt. - Woody75 (Denver) 16:58:24 01/27/10 here is a pic to clarify. - BeaZty 18:00:22 01/27/10 Should be a stud and acorn nut there, not a bolt. (n/m) - Fast300 22:20:24 01/27/10 ^^^ listen to them it is a nut on a STUD. NOT a BOLT (n/m) - 5280Z_nightstalker 13:01:53 01/29/10 lol, ok you win. the acorn nut. (n/m) - BeaZty 13:43:41 01/29/10 Buy the heli coil kit for the bolt size. ie 8mm, 10mm etc - Zjustignoreme 18:35:40 01/27/10 thanks, I will buy the 12mm helicoil kit for the acorn bolt. - BeaZty 09:50:57 01/29/10 12mm is too big - Fast300 18:02:30 01/29/10 Re: stripped threads inside bolt hole of plenum to balance tube. - Marty1Mc 06:39:12 01/30/10 Thanks Marty, your tips are greatly appreciated. - BeaZty 08:00:43 01/30/10 Re: Thanks Marty, your tips are greatly appreciated. - Marty1Mc 08:21:47 01/30/10 Re: "it really isn't that hard." Thats music to my ears... - BeaZty 11:03:54 01/30/10 If you can drill and tap a hole, and in aluminum >> - Gordo 93TT Daytona 19:19:47 02/01/10 HeliCoil kit measurements. For 12mm acorn nut stud. - BeaZty 22:38:18 01/31/10
Post a Followup	You cannot reply to this message because you are not logged in.