Subject	Yes, the ones in 199 look chamfered, for as good as the
Posted by	zellamay on January 23, 2010 at 6:28 PM
	This message has been viewed 109 times.
In Reply To	still confused, both ends look the same to me posted by ae300z on January 23, 2010 at 02:54 PM
Message	pictures are. I 'd want them in my hand to say for sure, or better pictures. The chamfered end should be obvious. The inside of the spring will have an angled surface that is cleaner looking than the surface of the raw material. It will look like the top and bottom surfaces of the spring.
Follow Ups	valve spring install help - ae300z 10:46:47 01/23/10 Re: valve spring install help - Tech@EPR 13:34:36 01/23/10 still confused, both ends look the same to me - ae300z 14:54:34 01/23/10 Seems to me the ends of the spring in the first picture - jzack 16:49:51 01/23/10 Yes, the ones in 199 look chamfered, for as good as the - zellamay 18:28:48 01/23/10 There is nothing obvious on either end . I'll contact - ae300z 19:22:53 01/23/10 I contacted JWT today, they said either end, there is - ae300z 20:18:11 01/25/10 Perhaps it was from an earlier design - Broke_as_**** 23:37:50 01/25/10 I did ask. The gentleman I was speaking with did not - ae300z 00:21:34 01/26/10 Wait, are you saying there is a difference between ends, - zellamay 16:23:06 01/26/10 Well initially I didn't think there was a difference, but - ae300z 17:34:29 01/26/10
Post a Followup	You cannot reply to this message because you are not logged in.