Subject	Re: valve spring install help
Posted by	Tech@EPR on January 23, 2010 at 1:34 PM
	This message has been viewed 141 times.
In Reply To	valve spring install help posted by ae300z on January 23, 2010 at 10:46 AM
Message	look at the end of each spring...there is a chamfer that is machined into one of the ends to indicate which is top/bottom. Let me know if you still have issues.
Follow Ups	valve spring install help - ae300z 10:46:47 01/23/10 Re: valve spring install help - Tech@EPR 13:34:36 01/23/10 still confused, both ends look the same to me - ae300z 14:54:34 01/23/10 Seems to me the ends of the spring in the first picture - jzack 16:49:51 01/23/10 Yes, the ones in 199 look chamfered, for as good as the - zellamay 18:28:48 01/23/10 There is nothing obvious on either end . I'll contact - ae300z 19:22:53 01/23/10 I contacted JWT today, they said either end, there is - ae300z 20:18:11 01/25/10 Perhaps it was from an earlier design - Broke_as_**** 23:37:50 01/25/10 I did ask. The gentleman I was speaking with did not - ae300z 00:21:34 01/26/10 Wait, are you saying there is a difference between ends, - zellamay 16:23:06 01/26/10 Well initially I didn't think there was a difference, but - ae300z 17:34:29 01/26/10
Post a Followup	You cannot reply to this message because you are not logged in.