Subject	Pickle Fork.
Posted by	Jehannum on January 21, 2010 at 6:37 PM
	This message has been viewed 189 times.
In Reply To	How do you remove the outer tierod from the spindle? posted by collegeboy on January 21, 2010 at 03:08 PM
Message	You can rent 'em at Autozone. Any other method is just going to mushroom the head of the tie rod threads. Your powers are useless! I'm wearing my tinfoil underwear!
Follow Ups	How do you remove the outer tierod from the spindle? - collegeboy 15:08:01 01/21/10 I had no luck with that method either. - opus300zx 15:18:52 01/21/10 2nd (n/m) - Turnerscasa (Dallas) 15:55:21 01/21/10 Are you replacing the outer tie rod end? If so, you can - 300MPH 15:23:07 01/21/10 I had to use a tie rod puller on the rear outer tie rods. - Wright (Ca) 15:33:40 01/21/10 PB Blaster and a hammer worked perfectly! - collegeboy 16:05:06 01/21/10 Lets see some pics (n/m) - MannyB 16:35:20 01/21/10 Sorry dude. I didn't really take pictures. - collegeboy 08:33:15 01/22/10 Re: PB Blaster and a hammer worked perfectly! - toykoz32 16:57:35 01/21/10 You have to hammer the body of the spindle to vibrate - Ashman2k2 17:35:18 01/21/10 When I did mine..... - zx299 17:41:01 01/21/10 yes i used a puller tool as well - gt300zxtt 20:47:05 01/21/10 Pickle Fork. - Jehannum 18:37:49 01/21/10 Negative. Will ruin boot. (n/m) - Ashman2k2 19:02:14 01/21/10 2nd that big time. just experienced it (n/m) - KasbeKZ 19:05:49 01/21/10 Energy Suspension 913104-G: $3.99 (n/m) - Jehannum 19:10:24 01/21/10 Good to know. But still not the optimal technique. - Ashman2k2 19:15:30 01/21/10 The correct answer is a Tie Rod/Pitman Arm Puller - aliaZ 20:47:54 01/21/10 Same one I used, worked perfectly. (n/m) - Wright (Ca) 21:10:44 01/21/10 i've been meaning to pick one of these up. (n/m) - Halo Z 22:14:12 01/21/10 I use this tool. I think Sears sells it as well. - Woody75 (Denver) 08:18:47 01/22/10 thanks for the link - aliaZ 11:34:22 01/22/10 I think this is the tool listed/shown in the manual as well. (n/m) - Woody75 (Denver) 10:41:50 01/26/10
Post a Followup	You cannot reply to this message because you are not logged in.