Subject	You can get just the injector connectors.
Posted by	MixManMash on January 14, 2010 at 4:37 PM
	This message has been viewed 87 times.
In Reply To	new vs. old injector posted by supersh0cker on January 14, 2010 at 03:38 PM
Message	If you do that you will have to cut off the old connectors and solder in the new ones. However, I would double check the condition of your whole EFI harness. From the age / use, it might be best to replace it. However, you will need a 95 EFI harness for the new style injectors. If you go that route, be prepared to spend a bit extra for a 94+ Cam Angle Sensor. You will also have to cut off the A/C Connector from your old harness and splice it into the new one. As well, the 95 has better connectors/seals from what I have seen and it has some wiring changes so that your injectors don't have +12V going to them until the ignition is in the on position (the old harness has +12V going to them all the time).
Follow Ups	new vs. old injector - supersh0cker 15:38:25 01/14/10 You can get just the injector connectors. - MixManMash 16:37:58 01/14/10 Considering all that work and cost might be better >>> - ZUL8TR 06:35:05 01/15/10 ^^^ Good advice. (n/m) - MixManMash 14:29:42 01/15/10
Post a Followup	You cannot reply to this message because you are not logged in.