Subject	Re: How do I secure the metal PCV elbow to the left valve co
Posted by	SlickTopSmiTTy on January 11, 2010 at 2:32 PM
	This message has been viewed 106 times.
In Reply To	How do I secure the metal PCV elbow to the left valve cover? posted by aeron8 on January 11, 2010 at 01:49 AM
Message	I had the same thing happen to me. One of the guys at Z1 told me to pound the elbow back in with a rubber mallet and then use a metal punch to indent the top of the housing where the end of the elbow meets valve cover. Apparently the indentation should keep it in place. I ended up just pounding the elbow into the housing and it has been fine for about six months now (without the indentation). Ive got the back end of a cheap billiards cue that I use for force in some tight places where you cant full swing a rubber mallet. Hold the rubber end of the cue on the elbow and use a normal hammer on the other end.
Follow Ups	How do I secure the metal PCV elbow to the left valve cover? - aeron8 01:49:28 01/11/10 Re: How do I secure the metal PCV elbow to the left valve co - SlickTopSmiTTy 14:32:49 01/11/10 Hi temp o2 safe RTV is another way to do it.... (n/m) - jzack 18:16:20 01/11/10 A dab of JB Weld but clean the oil off (n/m) - Audioquest 08:14:17 01/13/10
Post a Followup	You cannot reply to this message because you are not logged in.