Subject	Another question: can you position the hoist to the side?
Posted by	evan_aggie on January 11, 2010 at 9:57 AM
	This message has been viewed 84 times.
In Reply To	if you follow the posted FAQ posted by Shiers69 on January 11, 2010 at 09:23 AM
Message	Most pulls I've seen always have the hoist right in front, which I imagine is to avoid interferring with jack stands or whatever is supporting the vehicle. My garage is not very deep, so I was thinking I might need to go in from the side or at an angle if possible. Again, I'm not even sure if this is feasible, but I was wondering if anyone else had any experience performing the engine pull with a hoist this way.
Follow Ups	removing engine - required hoist boom length and weight? - evan_aggie 08:14:48 01/11/10 if you follow the posted FAQ - Shiers69 09:23:01 01/11/10 Another question: can you position the hoist to the side? - evan_aggie 09:57:41 01/11/10 Two reasons not to: 1) You will need fore-aft motion to - zellamay 12:37:20 01/11/10 If your garage is not deep enough then back car in and - Gordo 93TT Daytona 13:54:18 01/11/10 Other night it was 14F... - evan_aggie 16:35:10 01/11/10 Re: removing engine - required hoist boom length and weight? - CmyZ 12:07:26 01/11/10 With my 2-ton I have to put it on the half-ton setting to - Wright (Ca) 12:54:59 01/11/10
Post a Followup	You cannot reply to this message because you are not logged in.