Subject	You perform two dyno pulls....
Posted by	zx299 on December 27, 2009 at 4:19 PM
	This message has been viewed 106 times.
In Reply To	Ash would know... posted by ZTurboFan on December 27, 2009 at 03:16 PM
Message	One with the VTC pemanently "on" and one with it permanently "off"..... you then set the release point at where the two dyno charts cross. "If you own a 300zx, you don't have time for a hobby" "If you own more than one 300zx, you don't have time for a life"
Follow Ups	VTC Release and bigger cams - nzryan 20:31:25 12/26/09 Well its set at the RPM you decide to set it. - kickerzx 13:22:33 12/27/09 Ash would know... - ZTurboFan 15:16:02 12/27/09 You perform two dyno pulls.... - zx299 16:19:47 12/27/09 That does sound right! - ZTurboFan 21:11:08 12/27/09 Thanks guys - was more after info on cams - nzryan 03:39:42 12/28/09 I believe that SZ set mine at 6100 with Wild's. (n/m) - HighPsi 08:41:24 12/28/09
Post a Followup	You cannot reply to this message because you are not logged in.