Subject	Ash would know...
Posted by	ZTurboFan on December 27, 2009 at 3:16 PM
	This message has been viewed 162 times.
In Reply To	VTC Release and bigger cams posted by nzryan on December 26, 2009 at 08:31 PM
Message	But IIRC, you need to get on the dyno. You set the VTC release RPM to be at your peak HP. Moving it downwards is not right - you want it to go up...unfortunately my rusty mind isn't remembering clearly... So, This is a dyno chart on my Z where VTC release was set at 5900 rpm. Look what happened to the cars power the moment it hits that... So I started to increase the VTC release RPM...and I think wound up setting it so high it would never reach it.
Follow Ups	VTC Release and bigger cams - nzryan 20:31:25 12/26/09 Well its set at the RPM you decide to set it. - kickerzx 13:22:33 12/27/09 Ash would know... - ZTurboFan 15:16:02 12/27/09 You perform two dyno pulls.... - zx299 16:19:47 12/27/09 That does sound right! - ZTurboFan 21:11:08 12/27/09 Thanks guys - was more after info on cams - nzryan 03:39:42 12/28/09 I believe that SZ set mine at 6100 with Wild's. (n/m) - HighPsi 08:41:24 12/28/09
Post a Followup	You cannot reply to this message because you are not logged in.