Subject	Question regarding front Lower Control arm install
Posted by	Rated Z on December 24, 2009 at 12:07 AM
	This message has been viewed 372 times.
Message	Replacing my bent one for a straight control arm on my driverside has been quite simple until i hit this snag. I have the new control arm on, but cant get the nut tightened on the bolt coming from the ball joint because it is spinning freely. there is nothing for me to grab with pliers and nothing to in any way brace the bolt so it doesnt spin while i attempt to tighten the nut. I was wondering if there was a special technique i am not aware about? Thanks in advance!
Follow Ups	Question regarding front Lower Control arm install - Rated Z 00:07:20 12/24/09 c-clamp it to put pressure on the ball joint to keep it - Dane (Houston) 01:25:51 12/24/09 Re: Question regarding front Lower Control arm install - lurker_nz 01:30:02 12/24/09 Used a jack and it tightened right up thanks! (n/m) - Rated Z 04:01:57 12/24/09
Post a Followup	You cannot reply to this message because you are not logged in.