Subject	As you note the solder and seal is the best but it >>>
Posted by	ZUL8TR on December 22, 2009 at 7:31 AM
	This message has been viewed 147 times.
In Reply To	Replacing Injector Plugs posted by The Silent Genius on December 22, 2009 at 04:19 AM
Message	can be tedious done in place. I used crimp connectors then sealed connection with hi temp brush on liquid tape (better seal than heat shrink IMO) and additionally wrapped each connection with hi temp electric tape. Worked for me with no problems. Make sure you cut away any corroded wire. Use dielectric grease in conector before you plug them back together. ZUL8TR in Orlando,FL
Follow Ups	Replacing Injector Plugs - The Silent Genius 04:19:25 12/22/09 As you note the solder and seal is the best but it >>> - ZUL8TR 07:31:32 12/22/09 what about.... - The Silent Genius 10:31:25 12/22/09 I don't care for them because of 6 possibilities >>> - ZUL8TR 15:05:19 12/22/09 I see you have a 90 have you upgraded the injectors to >> - ZUL8TR 15:09:02 12/22/09 Old style - The Silent Genius 01:47:08 12/23/09 take a look at this - fanta-z 01:04:51 12/24/09 thanks - The Silent Genius 09:20:26 12/24/09
Post a Followup	You cannot reply to this message because you are not logged in.