Subject	The original line i have to "T" into or bypass (i will "T")
Posted by	DKaway on December 19, 2009 at 10:56 AM
	This message has been viewed 106 times.
In Reply To	Re: SPI P-series boost guage question posted by craigz96tt on December 19, 2009 at 08:48 AM
Message	is approximately 6mm hose. my boost gauge came with a hose approx. 4 mm hose and the barrel connector previously mentioned. when I "T" into the 6 mm hose, I HAVE TO use the supplied 4mm (approx.) hose and barrel to connect to the gauge, then? I might be overthinking this, just making sure for proper installation
Follow Ups	SPI P-series boost guage question - DKaway 05:45:40 12/19/09 Re: SPI P-series boost guage question - craigz96tt 08:48:28 12/19/09 The original line i have to "T" into or bypass (i will "T") - DKaway 10:56:50 12/19/09 Re: The original line i have to "T" into or bypass (i will "T") - ZTurboFan 13:49:57 12/19/09 oh, btw... - ZTurboFan 13:55:18 12/19/09 the needle started to rattle in my SPI gauge and became - Dane (Houston) 12:09:02 12/20/09
Post a Followup	You cannot reply to this message because you are not logged in.