Subject	I flooded my motor this summer by not getting the injector
Posted by	apepper7191 on December 16, 2009 at 9:00 PM
	This message has been viewed 96 times.
In Reply To	very unlikely posted by ZTurboFan on December 16, 2009 at 03:44 PM
Message	lower o-rings fully sealed and bent my connecting rod. The motor turned over originally but had a horrible knock. Turned the car off to attempt to troubleshoot. Cranked the motor over again and it ran but the knock was even worse so I immediatly turned it off. Pulled the plugs to find a few cylinders filled with gas. Upon pulling the motor out of the car I found the number 1 cylinder had a bent connecting rod and I never even let the car get above 2k rpm. But I completely agree that the starter couldnt bend the rod. Be careful though because it will eat through the flywheel teeth if your motor wont budge.
Follow Ups	What are the odds the starter bent the rods - twooton 13:27:51 12/16/09 unlikely (n/m) - aliaZ 13:52:28 12/16/09 very unlikely - ZTurboFan 15:44:58 12/16/09 I flooded my motor this summer by not getting the injector - apepper7191 21:00:36 12/16/09 That sucks... - ZTurboFan 23:19:18 12/16/09 I would imagine there would be failure elsewhere before - HighPsi 16:05:52 12/16/09 1 in 10,000 (n/m) - ZUL8TR 12:26:35 12/17/09
Post a Followup	You cannot reply to this message because you are not logged in.