Subject	Re: I installed the same rods and boots.
Posted by	Da Flash on December 16, 2009 at 8:35 PM
	This message has been viewed 125 times.
In Reply To	I installed the same rods and boots. posted by Trailboss on December 16, 2009 at 03:49 PM
Message	:Just heat up the boots with a heat gun and stretch them over the rod ends gently. Thanks for the reply!! That should work but, you would think that they would've made a little easier to install! The hole that I have to stretch is only 1/2" in diameter but the ball joint end is 1-1/2" in diameter. It appears that once you install the boot, inspecting the ball joint is going to be at least difficult.
Follow Ups	Powertrix adjustable tension rods question. - Da Flash 12:18:53 12/16/09 I installed the same rods and boots. - Trailboss 15:49:43 12/16/09 Re: I installed the same rods and boots. - Da Flash 20:35:45 12/16/09
Post a Followup	You cannot reply to this message because you are not logged in.