Subject	If you are talking about the flat/rounded off bolt,
Posted by	Wingzerro93 on December 07, 2009 at 3:43 PM
	This message has been viewed 71 times.
In Reply To	Re: So looks like you'll need to replace the ignition switch -- posted by lbw46 on December 06, 2009 at 11:49 AM
Message	then use a center punch on it to get a spot started. The use a sharp too and a hammer to tap it and turn it (like a normal bolt)
Follow Ups	ignition switch - lbw46 23:23:44 12/04/09 giggle the wheel while trying to turn the key - JustinSCZ32 18:51:13 12/05/09 Re: giggle the wheel while trying to turn the key (n/m) - lbw46 22:53:30 12/05/09 Re: Re: giggle the wheel while trying to turn the key - lbw46 23:10:44 12/05/09 So looks like you'll need to replace the ignition switch -- - jzack 09:52:30 12/06/09 Re: So looks like you'll need to replace the ignition switch -- - lbw46 11:49:09 12/06/09 If you are talking about the flat/rounded off bolt, - Wingzerro93 15:43:58 12/07/09 2nd. Or left hand drill bit. (n/m) - Black95 15:09:50 12/08/09 Re: giggle the wheel while trying to turn the key (n/m) - lbw46 22:55:57 12/05/09
Post a Followup	You cannot reply to this message because you are not logged in.