Subject	Might need to take it off and put loctite on the threads (n/m)
Posted by	Under_Powered on December 03, 2009 at 5:46 PM
	This message has been viewed 149 times.
In Reply To	spinin shift knob posted by Z GUNMETAL LOVER on December 03, 2009 at 05:38 PM
Message
Follow Ups	spinin shift knob - Z GUNMETAL LOVER 17:38:49 12/03/09 Might need to take it off and put loctite on the threads (n/m) - Under_Powered 17:46:51 12/03/09 Re: Might need to take it off and put loctite on the threads - Z GUNMETAL LOVER 18:38:13 12/03/09 Lefty loosey, righty tighty. - Under_Powered 17:46:41 12/04/09 a thick towel and a pipe wrench (n/m) - Zblackbeast 13:09:28 12/05/09 It spins freely, or just isn't tight when turned forward? - BobbyT 22:08:31 12/03/09 The glue from the factory is "semi-permanent" as well. - Under_Powered 17:48:16 12/04/09 2nd on the fabric. I used paper. (n/m) - JustinSCZ32 20:09:32 12/05/09 Re: It spins freely, or just isn't tight when turned forward? - Z GUNMETAL LOVER 15:19:21 12/07/09 You didn't answer my question - BobbyT 20:44:21 12/07/09
Post a Followup	You cannot reply to this message because you are not logged in.