Subject	Re: What is the valve cover torque spec?
Posted by	91TurboZ on May 31, 2009 at 6:53 PM
	This message has been viewed 723 times.
In Reply To	What is the valve cover torque spec? posted by Zarcasm(Hfd, CT) on May 31, 2009 at 06:19 PM
Message	The intake valve covers should be tightened to 0.7-2.2 ft-lbs while the exhaust valve covers should be 4.6-6.1 ft-lbs. I'm not seeing a torque spec for the ornament cover bolts. I'm also not sure if there is a specific order for tightening these bolts and can't find one in the FSM.
Follow Ups	What is the valve cover torque spec? - Zarcasm(Hfd, CT) 18:19:01 05/31/09 Re: What is the valve cover torque spec? - 91TurboZ 18:53:23 05/31/09 Thanks, that was helpful. (n/m) - Zarcasm(Hfd, CT) 23:24:37 06/01/09
Post a Followup	You cannot reply to this message because you are not logged in.