Subject	I dont think I have a boost leak because my MBC will hold
Posted by	Z Driver on September 23, 2008 at 10:05 PM
	This message has been viewed 162 times.
In Reply To	boost could be falling off from a boost leak after posted by The Devils Z on September 22, 2008 at 08:52 PM
Message	boost at 10psi when I set it to 10psi. But it will fall off from 15psi to 12psi when I set it there. Should both O2 sensors (left & right) swing back and forth on Datascan if normal?
Follow Ups	A/F Base # , O2 sensor # on Datascan and a few questions - Z Driver 12:25:56 09/22/08 As far as the boost falling off - FuerGrissa 13:41:31 09/22/08 Re: As far as the boost falling off - Z Driver 13:56:17 09/22/08 same boost problem - ricky6991 15:10:50 09/22/08 Does your MBC only have one knob? - FuerGrissa 17:37:57 09/22/08 yes it has a knob, 1 inlet, and 1 outlet....that's all (n/m) - Z Driver 21:42:30 09/22/08 profec is a huge diff.... install it you will see. (n/m) - ricky6991 22:05:28 09/22/08 Let me see how many of these I can answer... - kkrofft (OH) 14:10:17 09/22/08 Thanks for correcting my mistake (n/m) - FuerGrissa 17:41:33 09/22/08 I did keep WOT for a period (at least a few seconds after - Z Driver 22:08:21 09/23/08 Re: A/F Base # , O2 sensor # on Datascan and a few questions - txq45 14:16:13 09/22/08 boost could be falling off from a boost leak after - The Devils Z 20:52:36 09/22/08 I dont think I have a boost leak because my MBC will hold - Z Driver 22:05:16 09/23/08 Yes (n/m) - The Devils Z 07:29:58 09/25/08
Post a Followup	You cannot reply to this message because you are not logged in.