Subject	same boost problem
Posted by	ricky6991 on September 22, 2008 at 3:10 PM
	This message has been viewed 195 times.
In Reply To	Re: As far as the boost falling off posted by Z Driver on September 22, 2008 at 01:56 PM
Message	had a cheap manual boost controller... would spike to 16 then go to 12 an hold. profecb2 solved my problem. its just hard to set the profec 2. also most likly have boost leaks.
Follow Ups	A/F Base # , O2 sensor # on Datascan and a few questions - Z Driver 12:25:56 09/22/08 As far as the boost falling off - FuerGrissa 13:41:31 09/22/08 Re: As far as the boost falling off - Z Driver 13:56:17 09/22/08 same boost problem - ricky6991 15:10:50 09/22/08 Does your MBC only have one knob? - FuerGrissa 17:37:57 09/22/08 yes it has a knob, 1 inlet, and 1 outlet....that's all (n/m) - Z Driver 21:42:30 09/22/08 profec is a huge diff.... install it you will see. (n/m) - ricky6991 22:05:28 09/22/08 Let me see how many of these I can answer... - kkrofft (OH) 14:10:17 09/22/08 Thanks for correcting my mistake (n/m) - FuerGrissa 17:41:33 09/22/08 I did keep WOT for a period (at least a few seconds after - Z Driver 22:08:21 09/23/08 Re: A/F Base # , O2 sensor # on Datascan and a few questions - txq45 14:16:13 09/22/08 boost could be falling off from a boost leak after - The Devils Z 20:52:36 09/22/08 I dont think I have a boost leak because my MBC will hold - Z Driver 22:05:16 09/23/08 Yes (n/m) - The Devils Z 07:29:58 09/25/08
Post a Followup	You cannot reply to this message because you are not logged in.