Subject	Motor Mounts are brand new
Posted by	LoqueZX(CA) on September 20, 2008 at 1:30 PM
	This message has been viewed 147 times.
In Reply To	First for the record and others who will read this and do>> posted by ZUL8TR on September 19, 2008 at 07:48 PM
Message	Had them replaced when I did my swap. However, I found out later (when I had other work done) that my jack of a mechanic left a bolt out. OperationZ in northridge had it on the lift and showed me sure enough that a bolt was missing. Wondering if this is the problem then. Also told me that only way to get it bolted properly with all bolts is to take everything back out. Argh.
Follow Ups	Drive Line removal/installation - LoqueZX(CA) 22:38:24 09/17/08 Why? If there is an actual driveshaft vibration, it's likely - Audioquest 22:59:51 09/17/08 No center bearing - LoqueZX(CA) 23:05:01 09/17/08 Re: Drive Line removal/installation - Bret (Generation Z) 00:31:40 09/18/08 * take half of the bolts out, - Woody75 (Denver) 13:29:50 09/18/08 After balance you may still have vibe issues. If so >>> - ZUL8TR 14:47:40 09/18/08 Vibration only at idle - LoqueZX(CA) 21:07:49 09/18/08 Silly question: how can you notice a wobble in the DS when - Audioquest 13:32:17 09/19/08 First for the record and others who will read this and do>> - ZUL8TR 19:48:12 09/19/08 Motor Mounts are brand new - LoqueZX(CA) 13:30:41 09/20/08
Post a Followup	You cannot reply to this message because you are not logged in.