Subject	Make sure the smaller gauge wire is connected >
Posted by	my91z on September 20, 2008 at 11:43 AM
	This message has been viewed 116 times.
In Reply To	z will not start after replacing ECU harness posted by ricerdaddy on September 19, 2008 at 09:41 PM
Message	at the battery. After my swap I turned the key and it wouldn't start. I had forgotten to re-attach one of the smaller wires to the battery. It was a positive wire I think. Mike --------------------------------------------------------
Follow Ups	z will not start after replacing ECU harness - ricerdaddy 21:41:56 09/19/08 Check your ground connections (n/m) - Marc (NJ) 21:47:02 09/19/08 I checked the ground connection they are OK. I think it's - ricerdaddy 23:05:48 09/19/08 pulled the CAS. unplug one of the connectors on the PTU. - ricerdaddy 12:45:01 09/20/08 Make sure the smaller gauge wire is connected > - my91z 11:43:48 09/20/08
Post a Followup	You cannot reply to this message because you are not logged in.