Subject	After balance you may still have vibe issues. If so >>>
Posted by	ZUL8TR on September 18, 2008 at 2:47 PM
	This message has been viewed 133 times.
In Reply To	Drive Line removal/installation posted by LoqueZX(CA) on September 17, 2008 at 10:38 PM
Message	you can try the DS is different bolt positions at the rear end flange. You have 6 positions with the TT and I believe 4 with the NA. This is typical procedure to reduce DS lateral runout. Have you replaced the tranny rear isolater mount. They sag with age and that effects the DS angle at the U joints especially the front joint. ZUL8TR in Orlando,FL
Follow Ups	Drive Line removal/installation - LoqueZX(CA) 22:38:24 09/17/08 Why? If there is an actual driveshaft vibration, it's likely - Audioquest 22:59:51 09/17/08 No center bearing - LoqueZX(CA) 23:05:01 09/17/08 Re: Drive Line removal/installation - Bret (Generation Z) 00:31:40 09/18/08 * take half of the bolts out, - Woody75 (Denver) 13:29:50 09/18/08 After balance you may still have vibe issues. If so >>> - ZUL8TR 14:47:40 09/18/08 Vibration only at idle - LoqueZX(CA) 21:07:49 09/18/08 Silly question: how can you notice a wobble in the DS when - Audioquest 13:32:17 09/19/08 First for the record and others who will read this and do>> - ZUL8TR 19:48:12 09/19/08 Motor Mounts are brand new - LoqueZX(CA) 13:30:41 09/20/08
Post a Followup	You cannot reply to this message because you are not logged in.