Subject	Would guess that at some point the parts supplier
Posted by	jzack on September 15, 2008 at 6:51 PM
	This message has been viewed 102 times.
In Reply To	IACV unit posted by inf on September 15, 2008 at 04:57 PM
Message	figure out a way to make them for less money? Not needing to mill out a larger hole -- using a readily available spring (from another assembly process) vs. a custom part? Just a guess...
Follow Ups	IACV unit - inf 16:57:06 09/15/08 and then some of them have the square empty - inf 17:11:17 09/15/08 Would guess that at some point the parts supplier - jzack 18:51:48 09/15/08 Don't know why, but I know that the open ones are from - Milo (SATX) 19:20:04 09/15/08
Post a Followup	You cannot reply to this message because you are not logged in.