Subject	Don't seem to be a lot of folks that report this issue --
Posted by	jzack on September 14, 2008 at 1:45 PM
	This message has been viewed 117 times.
In Reply To	Question on cam and crank seals. I will be doing the timing posted by ZUL8TR on September 14, 2008 at 11:02 AM
Message	so isn't that widespread. If you do have them and they aren't very deep they can be polished out. I've seen some posting on other forums where the new seal is installed but not set all the way "in" so that the contact point is shifted a bit away from the grove. FYI -- I cleaned up my VTC shafts using a Micromesh polishing cloth (3000 grit or so). Not sure it was really necessary but while I had it all apart figured why not? Left side is all cleaned up...
Follow Ups	Question on cam and crank seals. I will be doing the timing - ZUL8TR 11:02:55 09/14/08 Don't seem to be a lot of folks that report this issue -- - jzack 13:45:52 09/14/08 Thanks for the tips (n/m) - ZUL8TR 16:21:43 09/16/08
Post a Followup	You cannot reply to this message because you are not logged in.