Subject	Stock Boost Solonoids & EBCs
Posted by	JMWS.TTZ on September 10, 2008 at 6:05 PM
	This message has been viewed 107 times.
Message	Looking through the install write up for AVC-R, I noted that It wasnt necessary to remove the stock boost solonoids (some do, some dont). Im assuming the same is true for the Profec B Spec II, but I also know assumptions can kick you in the ass. What are the cons to leaving the stock solonoids active?
Follow Ups	Stock Boost Solonoids & EBCs - JMWS.TTZ 18:05:05 09/10/08 Disconnect solenoids (n/m) - Black95 21:31:58 09/10/08 Unplug electrical connectors, leave vac lines? (n/m) - JMWS.TTZ 23:18:44 09/10/08 I'm in the same place - seems to be preference - bliZard 08:15:21 09/11/08 DEfintiely best to run new hoses direct to the actuators - Audioquest 11:11:05 09/11/08 how did you reach the pass side one? - bliZard 13:58:26 09/11/08 No, from the bottom. Long nose pair of pliers and a little - Audioquest 19:41:13 09/11/08 2nd. (n/m) - itsghoZt 07:52:07 09/14/08 leaving them active will limit your boost - itsghoZt 07:50:43 09/14/08
Post a Followup	You cannot reply to this message because you are not logged in.