Subject	So if I understand you correctly....
Posted by	Multi_Read (MO) on September 09, 2008 at 3:33 PM
	This message has been viewed 128 times.
In Reply To	The coolant temp sensor sends a seperate feedback signal >> posted by ZUL8TR on September 09, 2008 at 07:27 AM
Message	is it then possible to remove the sender for the stock gauge, and use its hole for the new Defi sensor, leaving the stock coolant temp sensor in place? I'm just trying to go for the cleanest install. But it was suggested to me to leave the stock gauge for safety. Is that what you would do? Having given this some more thought, I want to use the Defi sensor with the gauge, not splice into anything else.
Follow Ups	Question about water temp sensors and ECU. - Multi_Read (MO) 21:02:10 09/08/08 The engine coolant tempature sensor is used by the ECM (n/m) - Fast300 00:20:36 09/09/08 The coolant temp sensor sends a seperate feedback signal >> - ZUL8TR 07:27:46 09/09/08 So if I understand you correctly.... - Multi_Read (MO) 15:33:27 09/09/08 Go for it, simple enough so try it. Is the electrical >>>> - ZUL8TR 11:48:53 09/10/08 I'm not sure what the difference is, sorry... - Multi_Read (MO) 21:12:18 09/10/08
Post a Followup	You cannot reply to this message because you are not logged in.