Subject	here.
Posted by	AntiHero on September 09, 2008 at 11:43 AM
	This message has been viewed 365 times.
In Reply To	Hesitation under acceleration - knock sensor? posted by Santa CruZin on September 09, 2008 at 07:03 AM
Message	Run through all this. probably a bad sensor connection. [ http://zhome.com/ZCMnL/PICS/hesitation/hesitation.html ] Sorry thats kind of the long version. here is the short version: clean these connections: temp sensor, ptu, tps, maf, cas. check plugs. Ohm test coil packs and injectors. clean CAS.* this step is not in the Faq. its super easy and should be done on all old cas's Antihero These 2530's ain't half bad ;)
Follow Ups	Hesitation under acceleration - knock sensor? - Santa CruZin 07:03:52 09/09/08 Ok, so I'm typing too fast this morning... - Santa CruZin 07:07:06 09/09/08 here. - AntiHero 11:43:05 09/09/08 Great advice! Thanks!!! (n/m) - Santa CruZin 15:56:41 09/09/08 more so the knock sensor harness, than the sensor itself. (n/m) - SuparexTT 16:02:52 09/09/08 check your injectors...i had the same hesitation. - gumby 12:43:02 09/10/08 Re: check your injectors...i had the same hesitation. - gumby 12:44:10 09/10/08 I'll look into that, thanks (n/m) - Santa CruZin 07:54:12 09/15/08
Post a Followup	You cannot reply to this message because you are not logged in.