Subject	Crap, maybe that's what's wrong.
Posted by	TriniTT on September 06, 2008 at 8:20 PM
	This message has been viewed 128 times.
In Reply To	Haha well it does. posted by Fake_Blood on September 06, 2008 at 08:04 PM
Message	I was wondering that, then I put the disk up to the flywheel that I took out and there's no way they could have fit. On top of that, the instructions I read said it could only go in one way, so I just threw it up there and torqued the bolts down. Bummer, well thanks for the heads up. I'll give it a shot and post tomorrow after I'm done. Cheers, JBrobst
Follow Ups	Clutch installation - now it's stuck engaged! - TriniTT 19:18:19 09/06/08 You need to verify that the slave piston is moving when - DAYTONAZ 19:31:29 09/06/08 Sorry, meant to mention I did that and it's working fine. (n/m) - TriniTT 19:41:56 09/06/08 This sounds stupid but... - Fake_Blood 19:55:50 09/06/08 I didn't think the disk could go in backwards? (n/m) - TriniTT 20:00:12 09/06/08 Haha well it does. - Fake_Blood 20:04:05 09/06/08 Crap, maybe that's what's wrong. - TriniTT 20:20:26 09/06/08 I could tell my clutch fork wasn't getting pushed enough. - Fake_Blood 20:48:42 09/06/08 2nd (n/m) - ZiNnYc 15:10:49 09/07/08 Turns out the pressure plate was bad. - TriniTT 21:13:06 09/07/08
Post a Followup	You cannot reply to this message because you are not logged in.