Subject	This sounds stupid but...
Posted by	Fake_Blood on September 06, 2008 at 7:55 PM
	This message has been viewed 114 times.
In Reply To	Clutch installation - now it's stuck engaged! posted by TriniTT on September 06, 2008 at 07:18 PM
Message	I had the same problem and it ended up my clutch disk was in backwards. I even replaced my slave cylinder because i thought it wasn't throwing far enough. Sometimes I amaze myself.
Follow Ups	Clutch installation - now it's stuck engaged! - TriniTT 19:18:19 09/06/08 You need to verify that the slave piston is moving when - DAYTONAZ 19:31:29 09/06/08 Sorry, meant to mention I did that and it's working fine. (n/m) - TriniTT 19:41:56 09/06/08 This sounds stupid but... - Fake_Blood 19:55:50 09/06/08 I didn't think the disk could go in backwards? (n/m) - TriniTT 20:00:12 09/06/08 Haha well it does. - Fake_Blood 20:04:05 09/06/08 Crap, maybe that's what's wrong. - TriniTT 20:20:26 09/06/08 I could tell my clutch fork wasn't getting pushed enough. - Fake_Blood 20:48:42 09/06/08 2nd (n/m) - ZiNnYc 15:10:49 09/07/08 Turns out the pressure plate was bad. - TriniTT 21:13:06 09/07/08
Post a Followup	You cannot reply to this message because you are not logged in.