Subject	You could put a test light (LED+resistor) on the harness
Posted by	jzack on September 06, 2008 at 4:56 PM
	This message has been viewed 91 times.
In Reply To	aac valve posted by pearllady91 on September 06, 2008 at 10:32 AM
Message	connector and see if it pulses - that would tell you there's a signal. It's also possible that the idle adjustment screw isn't set right. A few things to do... - Is engine timing set correctly? (just asking) - Is the TPS (voltage) adjusted correctly per the FSM procedure at 0.45 volts? - Did you try setting the idle per the FSM procedure? FYI -- A rough idle could be coming from things such as small vacuum leaks or injector connectors that are badly corroided. There's a write in the FAQ section on all the things to check for...
Follow Ups	aac valve - pearllady91 10:32:49 09/06/08 You could put a test light (LED+resistor) on the harness - jzack 16:56:48 09/06/08 I assume you did adjust the idle screw with it unplugged? (n/m) - Audioquest 20:50:50 09/06/08 Re: I assume you did adjust the idle screw with it unplugged? - pearllady91 15:41:38 09/08/08
Post a Followup	You cannot reply to this message because you are not logged in.