Subject	O-Ring seal between turbo and air inlet.
Posted by	Fake_Blood on September 03, 2008 at 1:13 PM
	This message has been viewed 131 times.
Message	So I have the GT600R Turbo kit and i called Z1 and they told me I don't need a gasket to mate the turbo inlet to the turbo inlet pipe because it has in O-Ring in the center. The stock turbo is metal to metal with a gasket. My question is, should there still be a gap between the two mating surfaces with the two bolts properly torqued down? I have them at a little more than 30ftlbs and im sure the seal is getting smashed but the metal surfaces don't touch. Is this normal and is there anyway to test the seal?
Follow Ups	O-Ring seal between turbo and air inlet. - Fake_Blood 13:13:20 09/03/08
Post a Followup	You cannot reply to this message because you are not logged in.