Subject	Changed the clutch, pedal to the floor.
Posted by	Je300zx on September 03, 2008 at 2:51 AM
	This message has been viewed 195 times.
Message	So I just put in a new throw out bearing, clutch, and pressure plate, all exedy oem with my dad this past weekend. He unfortunately didn't read the instructions when it came to the slave cylinder, and instead of just taking it off and leaving it attached to the hydraulic line he took the whole thing off. So we get it all done and all back together and my clutch pedal is to the floor obviously. So we bleed it, put new fluid in and it won't pump up. My dad has his finger over the hydraulic line down by the slave and he isn't getting much pressure, while I pump. Is my master cylinder gone? I just want to make sure, because now my car is 30 miles away. and have no means of transportation, thank god my work is within walking distance, but I want to make sure we have the problem pinpointed. I don't think it's the slave because like I said, we weren't even getting pressure from the master.
Follow Ups	Changed the clutch, pedal to the floor. - Je300zx 02:51:21 09/03/08 Bleeding the clutch must be done just right. I won't be - zellamay 03:48:14 09/03/08 Put it all back together. Fill up the MC reservoir. Put a - Audioquest 08:13:39 09/03/08 you know about both bleed points, right? (n/m) - AntiHero 09:45:15 09/03/08 Re: Changed the clutch, pedal to the floor. - Z1rider 15:20:23 09/03/08 Re: Changed the clutch, pedal to the floor. - Je300zx 22:21:20 09/03/08 Considering the system worked before you changed - Audioquest 07:55:39 09/04/08 Have you started the car to check? - BobbyT 00:29:17 09/04/08
Post a Followup	You cannot reply to this message because you are not logged in.