Subject	Make sure you plug over the whole you drilled to prevent
Posted by	Milo (SATX) on September 02, 2008 at 8:48 AM
	This message has been viewed 306 times.
In Reply To	How to install oem replacement wing...repost new pics posted by sawbonez on September 01, 2008 at 08:13 PM
Message	moisture and rust from forming. A simple adhesive hole plug should do the trick. And another trick for future reference it to take a little body panel sealer caulk (typical of the the taillight caulking we use) and put it around the bolt holes on the outside to prevent water from getting into the holes. Other than that, looks like a good install.
Follow Ups	How to install oem replacement wing...repost new pics - sawbonez 20:13:40 09/01/08 Nice write-up. Will VTF. (n/m) - Evan3zx(ca) 20:31:44 09/01/08 Is that just for the Powertrix/Iondynamics spoiler? - Woody75 (Denver) 23:12:11 09/01/08 what do you mean seen? interior is covered in plastic? (n/m) - AntiHero 23:43:33 09/01/08 That spot is not covered if I'm not mistaken. (n/m) - Woody75 (Denver) 15:01:32 09/02/08 correct. I just spent a very few minutes trying to fill the - sawbonez 19:24:35 09/02/08 hey Woody,my only experience is with the powertrix wing. - sawbonez 19:27:40 09/02/08 Make sure you plug over the whole you drilled to prevent - Milo (SATX) 08:48:46 09/02/08 yep, i agree, i caulked both areas as you said (n/m) - sawbonez 09:42:32 09/02/08
Post a Followup	You cannot reply to this message because you are not logged in.