Subject	Size of the IC's will not affect boost pressure or
Posted by	kkrofft (OH) on August 30, 2008 at 8:19 PM
	This message has been viewed 78 times.
In Reply To	Noob question about new smic's and boost. posted by Multi_Read (MO) on August 30, 2008 at 01:57 PM
Message	require you to change the setting on a manual boost controller. Find your leak. Be sure the caps are the right size. Recheck all the connections. Be sure the hoses on the IC's are clamped properly. I had one where I put the clamp too far away from the IC. The angle of the hose held it in place until boost reached 10 PSI then it acted like a BOV and the hose would leak because the clamp wasn't tightening on the neck of the IC. I found it by wiggling all the connections while doing the leak check. It didn't leak till I wiggled so it was a real beatch to find. KK
Follow Ups	Noob question about new smic's and boost. - Multi_Read (MO) 13:57:12 08/30/08 Size of the IC's will not affect boost pressure or - kkrofft (OH) 20:19:10 08/30/08 sound advice, - Multi_Read (MO) 02:20:14 08/31/08 smoke or boost leak tester. (n/m) - eyagel (Houston) 02:55:50 08/31/08 I did that already. - Multi_Read (MO) 01:20:59 09/01/08
Post a Followup	You cannot reply to this message because you are not logged in.