Subject	If you used the alignment tool
Posted by	RedTTZ91(OK) on August 30, 2008 at 10:00 AM
	This message has been viewed 102 times.
In Reply To	1st, did you use clutch alignment tool? posted by AntiHero on August 30, 2008 at 09:53 AM
Message	and the tranny is that close to the block, I put in a bolt on each side and slowly thread each side in moving back and fourth to stab it, I dont have time to sit there trying to push it in by hand, I have done this on every tranny I have switched and it hasnt failed me yet, but If it starts having to much resistance I obviously wouldn't keep going.
Follow Ups	what is the easyest way to install a tranny - PandaManZ32 04:31:41 08/30/08 Dont bolt up the trans if its not yet flush. - Medici (NorCal) 05:31:21 08/30/08 Just a question, you did have a line-up tool for the clutch? (n/m) - Audioquest 08:27:39 08/30/08 yes (n/m) - KasbeKZ 11:12:24 08/30/08 1st, did you use clutch alignment tool? - AntiHero 09:53:30 08/30/08 If you used the alignment tool - RedTTZ91(OK) 10:00:59 08/30/08 I use the same method of 'drawing' the trans into the - Gordo 93TT Daytona 23:41:44 08/31/08 Are we talking manual or auto tranny? - Woody75 (Denver) 10:03:02 08/30/08 If that is the issue he has to put a new MT pilot bushing in - kkrofft (OH) 10:05:23 08/30/08 im trying to use the 5spd from my 96 and the jdm motor .... - PandaManZ32 13:55:18 08/30/08 Was the clutch alignment tool easy to pull in and out - TTFairladyZ 10:44:08 08/31/08 I found that if one person wiggles/shakes the transmission - Crim 16:47:39 08/30/08 HaloZ came and helped me out. It went in just fine, - PandaManZ32 23:50:26 08/31/08
Post a Followup	You cannot reply to this message because you are not logged in.