Subject	what is the easyest way to install a tranny
Posted by	PandaManZ32 on August 30, 2008 at 4:31 AM
	This message has been viewed 142 times.
Message	Im doing a jdm motor swap and Im having trouble getting the tranny from my 96 to mate with the block. I put the motor in first and Im trying to put the transmission in 2nd and its going into place but stops about half an inch away from the block. Should I bolt the motor and tranny together then drop it in, or is there an easyer way that Im not thinking of. thanks for the help, Mike S. ____________________________________________________ [IMG]http://i279.photobucket.com/albums/kk143/pandamanZ32/mkztt.jpg[/IMG]
Follow Ups	what is the easyest way to install a tranny - PandaManZ32 04:31:41 08/30/08 Dont bolt up the trans if its not yet flush. - Medici (NorCal) 05:31:21 08/30/08 Just a question, you did have a line-up tool for the clutch? (n/m) - Audioquest 08:27:39 08/30/08 yes (n/m) - KasbeKZ 11:12:24 08/30/08 1st, did you use clutch alignment tool? - AntiHero 09:53:30 08/30/08 If you used the alignment tool - RedTTZ91(OK) 10:00:59 08/30/08 I use the same method of 'drawing' the trans into the - Gordo 93TT Daytona 23:41:44 08/31/08 Are we talking manual or auto tranny? - Woody75 (Denver) 10:03:02 08/30/08 If that is the issue he has to put a new MT pilot bushing in - kkrofft (OH) 10:05:23 08/30/08 im trying to use the 5spd from my 96 and the jdm motor .... - PandaManZ32 13:55:18 08/30/08 Was the clutch alignment tool easy to pull in and out - TTFairladyZ 10:44:08 08/31/08 I found that if one person wiggles/shakes the transmission - Crim 16:47:39 08/30/08 HaloZ came and helped me out. It went in just fine, - PandaManZ32 23:50:26 08/31/08
Post a Followup	You cannot reply to this message because you are not logged in.