Subject	Ill take a look at these too but I was under the impression
Posted by	jmt-z on August 29, 2008 at 2:49 PM
	This message has been viewed 164 times.
In Reply To	Re: Loss of power.... posted by KasbeKZ on August 29, 2008 at 02:37 PM
Message	that if your MAF took a dump then you wouldnt be able to rev over 2k, if you car would even stay running at all. "If everything seems under control, you're just not going fast enough." - Mario Andretti
Follow Ups	Loss of power.... - jmt-z 09:20:12 08/29/08 Re: Loss of power.... - KasbeKZ 09:39:27 08/29/08 Re: Re: Loss of power.... - jmt-z 10:08:43 08/29/08 Regapped the plug...checked all my vacuum hoses and went for - jmt-z 10:32:20 08/29/08 Re: Loss of power.... - KasbeKZ 10:45:51 08/29/08 It sounds just fine. When I step on the gas its almost - jmt-z 11:19:30 08/29/08 perhaps you have clogged catalytic converters ??? (n/m) - REDI4U 14:06:42 08/29/08 Re: perhaps you have clogged catalytic converters ??? - KasbeKZ 14:36:37 08/29/08 Ill add that to my list to check when i get under there - jmt-z 14:43:46 08/29/08 Re: Loss of power.... - KasbeKZ 14:37:56 08/29/08 Ill take a look at these too but I was under the impression - jmt-z 14:49:28 08/29/08 my guess is the clogged cats...especially if it idels fine (n/m) - REDI4U 14:57:35 08/29/08 Re: Ill take a look at these too but I was under the impression - KasbeKZ 16:21:42 08/29/08 Well it looks like my knock sensor is shot so that will be - jmt-z 16:10:15 08/29/08 Re: Well it looks like my knock sensor is shot so that will be - KasbeKZ 21:53:33 08/29/08 Well I soldered on a 1M ohm resistor and problem solved - jmt-z 14:46:17 08/30/08 Re: Well I soldered on a 1M ohm resistor and problem solved - KasbeKZ 20:13:06 08/30/08
Post a Followup	You cannot reply to this message because you are not logged in.