Subject	Re: perhaps you have clogged catalytic converters ???
Posted by	KasbeKZ on August 29, 2008 at 2:36 PM
	This message has been viewed 164 times.
In Reply To	perhaps you have clogged catalytic converters ??? (n/m) posted by REDI4U on August 29, 2008 at 02:06 PM
Message	yeah that sounds pretty likely. you could drop the pipes right off the manifolds and give it a test run maybe to see if that fixes it
Follow Ups	Loss of power.... - jmt-z 09:20:12 08/29/08 Re: Loss of power.... - KasbeKZ 09:39:27 08/29/08 Re: Re: Loss of power.... - jmt-z 10:08:43 08/29/08 Regapped the plug...checked all my vacuum hoses and went for - jmt-z 10:32:20 08/29/08 Re: Loss of power.... - KasbeKZ 10:45:51 08/29/08 It sounds just fine. When I step on the gas its almost - jmt-z 11:19:30 08/29/08 perhaps you have clogged catalytic converters ??? (n/m) - REDI4U 14:06:42 08/29/08 Re: perhaps you have clogged catalytic converters ??? - KasbeKZ 14:36:37 08/29/08 Ill add that to my list to check when i get under there - jmt-z 14:43:46 08/29/08 Re: Loss of power.... - KasbeKZ 14:37:56 08/29/08 Ill take a look at these too but I was under the impression - jmt-z 14:49:28 08/29/08 my guess is the clogged cats...especially if it idels fine (n/m) - REDI4U 14:57:35 08/29/08 Re: Ill take a look at these too but I was under the impression - KasbeKZ 16:21:42 08/29/08 Well it looks like my knock sensor is shot so that will be - jmt-z 16:10:15 08/29/08 Re: Well it looks like my knock sensor is shot so that will be - KasbeKZ 21:53:33 08/29/08 Well I soldered on a 1M ohm resistor and problem solved - jmt-z 14:46:17 08/30/08 Re: Well I soldered on a 1M ohm resistor and problem solved - KasbeKZ 20:13:06 08/30/08
Post a Followup	You cannot reply to this message because you are not logged in.