Subject	Check the FSM EM-37
Posted by	Bezza on August 29, 2008 at 2:36 AM
	This message has been viewed 171 times.
In Reply To	Is it based on depth in the block or on the heads. posted by Sleeper_TTZ(SeKy) on August 27, 2008 at 11:19 PM
Message	Image sem659c (FSM EM section cylinder head installation) It has a diagram with little black circles where the short bolts go. [ http://300zx-twinturbo.com/cgi-bin/manual.cgi?list=em&dir=&config=&refresh=&direction=forward&scale=0&cycle=off&slide=37&design=default&total=70 ]
Follow Ups	Where does the small head bolt go... - Sleeper_TTZ(SeKy) 21:59:05 08/27/08 just use a small rod or stick and check the depth (n/m) - SkiFly01 22:23:21 08/27/08 Is it based on depth in the block or on the heads. - Sleeper_TTZ(SeKy) 23:19:56 08/27/08 Check the FSM EM-37 - Bezza 02:36:37 08/29/08 It's based on the holes in the block. (n/m) - Woody75 (Denver) 11:07:06 08/29/08
Post a Followup	You cannot reply to this message because you are not logged in.