Subject	I have seen them fitted to the turbo inlet flange
Posted by	Tektrader69 on August 26, 2008 at 7:09 AM
	This message has been viewed 92 times.
In Reply To	I don't think CHT's would even be possible on the Z posted by 550HPTT on August 22, 2008 at 04:46 PM
Message	It was drilled and tapped into the side if the square inlet flange, which made the probe tip project directly into the exhaust stream before the turbo It looked very effective
Follow Ups	Testing Greddy EGT probes, a few questions. - Bezza 21:44:11 08/21/08 The maximum reading from each probe isn't the issue. - Karl (MD) 13:20:46 08/22/08 Re: The maximum reading from each probe isn't the issue. - Bezza 14:49:44 08/22/08 I don't think CHT's would even be possible on the Z - 550HPTT 16:46:45 08/22/08 True. - Bezza 17:53:40 08/22/08 I have seen them fitted to the turbo inlet flange - Tektrader69 07:09:25 08/26/08 That would be an EGT probe - 550HPTT 09:32:30 08/26/08
Post a Followup	You cannot reply to this message because you are not logged in.