Subject	If thats where you want it sure but 2 bar is almost 30PSI
Posted by	kkrofft (OH) on August 25, 2008 at 6:34 PM
	This message has been viewed 100 times.
In Reply To	Re: Set them where you want to. Just make them the same. posted by Kurt300zx on August 25, 2008 at 05:05 PM
Message	I never set the full open pressure. I think the correct setting is "cracking" pressure where they first start to bleed off exhaust since after that it takes increasing boost to make up for the opening of the gates. I set mine to crack open at 11.5 PSI (.8 BAR). I defined crack open as the point where the little disk, valve, door or whatever just got loose enough to move with my finger. With my EBC off it boosts safely to about 12PSI. KKrofft
Follow Ups	GT525 Wastegate setup - Kurt300zx 10:02:59 08/25/08 Set them where you want to. Just make them the same. - kkrofft (OH) 16:40:31 08/25/08 Re: Set them where you want to. Just make them the same. - Kurt300zx 17:05:34 08/25/08 If thats where you want it sure but 2 bar is almost 30PSI - kkrofft (OH) 18:34:47 08/25/08 Re: If thats where you want it sure but 2 bar is almost 30PSI - Kurt300zx 03:04:41 08/26/08 Not exactly where you want to. - Dark Diver 02:37:10 08/30/08
Post a Followup	You cannot reply to this message because you are not logged in.