Subject	Tranny Problems please help
Posted by	MartPav on August 24, 2008 at 10:12 PM
	This message has been viewed 122 times.
Message	Hi all, I recently installed a SouthBend DXD OFE Stage 3 clutch that I purchased from ConceptZPerformance, I have changed the carrier bearing, pilot bushing and the slave and the master cylinders and I have bled the system several times, but the clutch wont disengage 100% so once the car is on the ground I connot shift into gear. The slave pushes about an inch but still the clutch is still gripping.... Any suggestions or opinions??? I really have rans out of options.... Thanks, Martin P. 1991 300ZX Twin Turbo
Follow Ups	Tranny Problems please help - MartPav 22:12:22 08/24/08 Adjust your clutch pedal for your new clutch. Search clutch - Josef(Houston) 22:54:21 08/24/08 Re: Adjust your clutch pedal for your new clutch. Search clutch - MartPav 06:39:37 08/25/08 Clutch fork spring or throw out bearing is not installed - doug8867 07:25:24 08/25/08
Post a Followup	You cannot reply to this message because you are not logged in.