Subject	I am using a Snap-on diagnostics tool to measure the mV.
Posted by	z-spott[HI] on August 21, 2008 at 7:00 PM
	This message has been viewed 145 times.
In Reply To	Two of the wires are for the heating element. posted by kkrofft (OH) on August 21, 2008 at 06:56 AM
Message	As far as the way its wired, i have them wired to the red and black. white wire is not connected. no vacuum leaks i know of. - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - I Pledge of Allegiance to the Z......[picture the Z w/o them pods.]
Follow Ups	Bosch 02 Sensors, wiring and resistors - z-spott[HI] 02:40:28 08/21/08 Two of the wires are for the heating element. - kkrofft (OH) 06:56:17 08/21/08 I am using a Snap-on diagnostics tool to measure the mV. - z-spott[HI] 19:00:24 08/21/08 the mV stays stationary, the value dosent go up or down. - z-spott[HI] 20:03:14 08/21/08 The white wire HAS to be connected for the O2's to work. - kkrofft (OH) 14:59:26 08/22/08 so to clarify, all three wires? (n/m) - z-spott[HI] 19:42:02 08/22/08 Actually, you can omit the heater wires in a pinch. - kkrofft (OH) 08:42:40 08/27/08
Post a Followup	You cannot reply to this message because you are not logged in.