Subject	Re: Question on required part needed for flywheel to crank insta
Posted by	90coupeconversion on August 21, 2008 at 12:38 AM
	This message has been viewed 147 times.
In Reply To	Question on required part needed for flywheel to crank insta posted by mp262 on August 20, 2008 at 11:47 PM
Message	The date on the TSB 3-19-04, by this point in production, most of Nissan's vehicles were equipped with a crank position sensor located in the transmission bellhousing. This sensor reads a series of "windows" in a metal ring that is attached to the flywheel. All Z32s 90-95 are not affected, due to the engine position sensors at the left exhaust cam(CAS). The 96 Z32 with OBD 2 diagnostics uses the sensor at the flywheel. I have heard for years that Transmission shops have to be very careful removing trannys that have this setup because if the ring is bent or dammaged, the crank sensor reading will be affected. A lot of chrysler products use this setup also.
Follow Ups	Question on required part needed for flywheel to crank insta - mp262 23:47:22 08/20/08 Re: Question on required part needed for flywheel to crank insta - 90coupeconversion 00:38:22 08/21/08 Re: Re: Question on required part needed for flywheel to crank insta (n/m) - mp262 17:37:39 08/21/08 Re: Re: Question on required part needed for flywheel to crank insta - mp262 17:39:13 08/21/08
Post a Followup	You cannot reply to this message because you are not logged in.