Subject	Re: Poping/Clunk noise after SPL Coilover install.....
Posted by	kuah@splparts.com on August 19, 2008 at 8:41 AM
	This message has been viewed 178 times.
In Reply To	Poping/Clunk noise after SPL Coilover install..... posted by nonstopna on August 19, 2008 at 02:27 AM
Message	Pull off the rear coilovers, make sure all locking rings are tight, and use an impact gun (short burst) to tighten the top nut (the nut holding the shock to the upper mount). Then make sure the preload is still set right.
Follow Ups	Poping/Clunk noise after SPL Coilover install..... - nonstopna 02:27:05 08/19/08 mine has no noises at all - sukhi95ttz 02:32:18 08/19/08 Well it was a 2 man Job...I was working on the fronts.. - nonstopna 02:38:00 08/19/08 No it won't damage anything (n/m) - kuah@splparts.com 08:42:09 08/19/08 Re: Poping/Clunk noise after SPL Coilover install..... - kuah@splparts.com 08:41:30 08/19/08 ...this guy is smart, where'd we find him ;) (n/m) - SuparexTT 12:25:09 08/19/08 Thanks... I will do that. (n/m) - nonstopna 15:44:30 08/19/08 I had that noise. It wound up being installer error - na300zx (OH) 13:24:40 08/19/08
Post a Followup	You cannot reply to this message because you are not logged in.