Subject	Clutch Issue remains, different problems!!!
Posted by	JSD-ZX on August 12, 2008 at 10:01 PM
	This message has been viewed 112 times.
Message	Initially, I was having a reverse issue, that has been ironed out, but the car will not go into gear. I have bleed all the air out, and I have adjusted the pedals and rod. All I can figure is that I'm having a problem internally. I would drop the tranny but the following is puzzling me. On jack stands, I can put the car in 1st, 2nd and reverse. The wheels would spin as they should. However, when the car is placed on the ground and I push the clutch pedal in I cannot put the car in 1st or reverse. Why would the car be able to go into gear on jack stands but not on the ground? I also removed the reverse lockout mechanism, would this cause an issue going into 1st?
Follow Ups	Clutch Issue remains, different problems!!! - JSD-ZX 22:01:56 08/12/08 The way you describe being able to go into gears when it is - 5280Z_nightstalker 00:53:59 08/13/08 It can only be one of 3 things: - Audioquest 08:51:51 08/13/08 Re: It can only be one of 3 things: - JSD-ZX 10:29:47 08/13/08 When you adjust the rod, only turn it up enough so - Audioquest 11:06:48 08/13/08 Re: When you adjust the rod, only turn it up enough so - JSD-ZX 17:52:52 08/13/08 Well, when you put the PP on, it has to be sucked down with - Audioquest 21:14:25 08/13/08 Re: Well, when you put the PP on, it has to be sucked down w - JSD-ZX 04:29:07 08/14/08 Only torque the bolts to 30 lbs MAX or the inserts will - Audioquest 07:54:32 08/14/08 Re: Only torque the bolts to 30 lbs MAX or the inserts will - JSD-ZX 09:55:11 08/14/08
Post a Followup	You cannot reply to this message because you are not logged in.