Subject	No I spliced it from the
Posted by	RedTTZ91(OK) on August 12, 2008 at 2:01 PM
	This message has been viewed 73 times.
In Reply To	Ok to make sure we are on the same page here.... posted by 550HPTT on August 12, 2008 at 12:18 PM
Message	connector off the comp to the fuse box and it works, which I stated in my original post.
Follow Ups	ac comp question, - RedTTZ91(OK) 22:27:02 08/11/08 does your AC blow cold? - aliaZ 22:32:07 08/11/08 Yes I recharged it and it blows cold when I hard wire - RedTTZ91(OK) 22:37:27 08/11/08 run a diagnostic on it - aliaZ 23:04:03 08/11/08 Re: ac comp question, - tyler@boostpro.net 22:43:42 08/11/08 already tried two different relaysm It works on every fire - RedTTZ91(OK) 22:49:16 08/11/08 Relays* Wire* Sorry its dark outside (n/m) - RedTTZ91(OK) 22:53:45 08/11/08 The A/C relay is between the fuse and the compressor though. - Karl (MD) 23:02:46 08/11/08 I know the relay is fine I touched it to the wiring on the - RedTTZ91(OK) 23:10:41 08/11/08 Ah, sorry, I misread your previous post. - Karl (MD) 23:26:04 08/11/08 Yeh, but the wire for the clutch goes into the harness and I - RedTTZ91(OK) 23:32:37 08/11/08 Did you try from both sides of the relay to make sure you - 550HPTT 10:02:44 08/12/08 Perhaps there's an issue with your A/C relay? (n/m) - Karl (MD) 22:44:44 08/11/08 Correction it turns off when the car turns off, but the - RedTTZ91(OK) 23:13:12 08/11/08 Hm, so where exactly do you have the compressor connected? (n/m) - Karl (MD) 23:52:50 08/11/08 I just ran it straight to the fuse box under the hood - RedTTZ91(OK) 00:22:58 08/12/08 In your own words :) - 550HPTT 07:49:41 08/12/08 Not much comes up for my problem - RedTTZ91(OK) 09:43:20 08/12/08 Re: Not much comes up for my problem - 550HPTT 09:59:47 08/12/08 its not the plug, I spliced in after the plug and - RedTTZ91(OK) 11:39:39 08/12/08 have you run a diagnostic yet? (n/m) - aliaZ 12:13:29 08/12/08 Ok to make sure we are on the same page here.... - 550HPTT 12:18:41 08/12/08 No I spliced it from the - RedTTZ91(OK) 14:01:17 08/12/08
Post a Followup	You cannot reply to this message because you are not logged in.