| Message |
Ladies and Gents...I'm frustrated because a repair that should have taken only an afternoon is dragging out. Does anyone have a copy of the Z32 service manual showing the clutch hydraulics? My copy is in STORAGE after we've moved and will be for a few months. I've replaced both master and slave, but the system acts as if there is a leak, a valve or something other than a straight tube connecting the master cylinder to the slave. I can verify that the master is pumping fluid just fine. When I put my finger over the tube that connects to the slave, there is no pressure, yet I can siphon fluid through it from the master cylinder end. If I had my compressor (also in STORAGE), I could test the integrity of the connecting tube. Having to guess at the hydraulic schematic is making this drag out. The online fiche is not for the Z32 and shows a simple connecting tube. If there is a scan online or if anyone can scan the pages in and send them to jvvlog@yahoo.com, I surely would appreciate it. Many thanks even for reading my frustration. John
|
 |
